1. Enter loco …
Walk to door located on right side of engine and open the door by clicking on it.
Look down toward bottom of door and press E to climb into engine.
Look left and click door to close it.
2. Activate Battery
3. Select Pantograph
4. Enter cab and sit in driver’s chair.
5. Insert Reverser Handle.
6. Set Reverser to Forward.
7. Wait for Air System to charge.
8. Set Signal Lights to WHITE.
9. Set Pantograph control to RAISE.
10. Set Circuit Breaker to CLOSE.
11. Set Passenger Door Selector.
Note: check platform before unlocking doors!
12. Set Passenger Doors Switch to OPEN.
When loading is complete, set Passenger Doors Switch to CLOSED.
13. Set Brake Key to ON.
14. Set Train Brake to RUNNING.
15. Set Handbrake to RELEASE.
16. Set Force Selector to 100%.
17. Set Speed Selector.
Additional notes.
► The Speed Selector (a.k.a. Force Selector) operates in 10 KPH increments only.
► About 1 KM before the next station stop, set the Force Selector to 0 (not off) to begin slowing the train.
► Use the train brake if necessary.
► Stop at the marker (good luck!).
► Check the Door Selector for proper side setting.
► Open and close doors when prompted to do so.
These instructions are based on the DB BR 112.1 tutorial included with DTG’s TSW2 Haupstrecke Hamburg-Lübeck route. Scenarios or sessions that begin with the driver sitting in the cab probably do not require some of the preliminary steps included here. In some cases, initial instructions will be provided in the activity, but this is not always the case.
Tom Pallen [Last Train To Clarksville]
Hope you enjoy the post for Train Sim World® 2 DB BR 112.1 DB :: Start-up & Operating Guide, If you think we should update the post or something is wrong please let us know via comment and we will fix it how fast as possible! Thank you and have a great day!
- Check All Train Sim World® 2 Posts List
Leave a Reply