Tips and Tricks for Steam Engine Simulator – How to Adjust Refresh Rate and Settings

Introduction

A simple method of boiling water

A smaller volume of water will typically require less time to heat than a larger volume. This is because of the lower proportion of mass to heat. It takes less time to heat a smaller amount of liquid due to less mass.

Desktop Setting

Refresh Rate

Adjust your Refresh Rate to 20-50.

Select Refresh Rate in Windows 11 by going to System > Display > Advanced display. The minimum rate available is 50.

In addition, by making use of third-party software you could be able to achieve even lower refresh rates.

Task Manager

Start the Task Manager, and then locate “atg-steam”.

Click on “atg Steam” and then select Efficiency mode.

Click on “atg steam” and choose “Go to Details”.

Right-click “atg” again in the details tab, and select “Set affinity”.

Set affinity to use only one core.

Steam Engine Setup

Annoy ATG

Disengage the brake – 0 percent

Set the temperature to 100%.

Switch off the relief valves

The throttle valve is set between 37% to 45%.

Press the Up Arrow and then press alt+tab.

Bake a cake

Select the water fill icon and add an amount of water. Alt-Tab is only available when the PSI has reached 250%. PSI resets when the temperature drops below 110degC. It is necessary to restart the process.

Video Guide

https://youtu.be/4zulvW3BDtA – [youtu.be]

Thank you for taking the time to read Steam Engine Simulator – How to Adjust Refresh Rate and Settings. This post was inspired by an exceptional piece by ColinLab. If you have any suggestions on how to enhance this content, please let us know in the comments. Have a fantastic day, and remember to visit us daily for new updates!